Xycd60 Manual Jun 2026

: Long-press the DOWN button to toggle the screen's auto-off mode.

The relay closes and charging begins when the battery voltage drops to or below the Lower Limit (dn) Deactivation:

While it's often sold as a "charger," it is actually a that does not change voltage or limit current itself; those are determined by your external charger or power source. Key Functional Modes

: Here, your battery is the input, and your load (e.g., a DC light) is the output. Set "UP" to the maximum voltage you allow (often left high as a failsafe). Set "dn" to the minimum safe voltage for your battery (e.g., 11.0V for a 12V battery). As long as the battery voltage is above 11.0V, the module will power your light. If the voltage drops to 11.0V, it will disconnect the light, preventing your battery from being drained completely and permanently damaged. xycd60 manual

The module supports TTL level UART communication (baud rate 9600), allowing you to read voltage and status or change settings via a computer or microcontroller.

: If the voltage exceeds settings, the relay will disconnect. Always ensure your charger voltage matches your battery system (e.g., use a 24V charger for a 24V battery) as the module does not change the voltage; it only acts as a switch.

Always ensure the input voltage matches the battery's requirements. The module is a switch, not a buck/boost converter. : Long-press the DOWN button to toggle the

The (and its variant ) is a specialized battery charging and discharging control module designed for a wide voltage range of DC 6V to 60V . It serves as an intelligent switch that prevents battery damage by cutting off the circuit when specific voltage thresholds are reached. 1. Core Functionality and Operating Modes

In this mode, the module connects the charger to the battery when the voltage drops below a set lower limit () and disconnects it when the battery reaches the upper limit ( UP ). Condition to Start: Voltage ≤is less than or equal to dn . Condition to Stop: Voltage ≥is greater than or equal to UP . 2. Discharging Mode (dn)

The relay closes and starts discharging (powering your load) when the battery voltage is at or above the Upper Limit (UP) Deactivation: Set "UP" to the maximum voltage you allow

Follow these steps to resolve the most common issues:

Check input voltage (must be 6-60V) and button press.