If you are struggling with a specific setup, for example, a vs fail-secure lock, it is highly recommended to consult the full V2000-c manual PDF for detailed diagrams.
A: No, the V2000-c is a standalone controller . It does not have WiFi, Bluetooth, or Ethernet. For remote access, pair it with a separate network-enabled relay.
| J1 Jumper Position | COM (J3) Connection | PUSH1 & COM State | Use Case | | :--- | :--- | :--- | :--- | | | GND | Normally Open | Fail-secure electric strike | | NC | GND | Normally Closed | Fail-safe magnetic lock | | NO | 12V | Normally Open (Outputs 12V) | Directly powering a low-current device | | NC | 12V | Normally Closed (Outputs 12V) | Directly powering a low-current device | | NO | Not Connected | Normally Open (Dry Contact) | General relay use | | NC | Not Connected | Normally Closed (Dry Contact) | General relay use | V2000-c Rfid Access Control User Manual
The V2000-C is a 125KHz RFID standalone access control keypad designed for single-door security, supporting up to 1,000 users with card or PIN access. Programming involves entering a master code to add/delete users, configure door open times, and manage system settings. Official digital copies of the V2000-C User Manual are available at www.goldbridgesz.com
and operates primarily with 125KHz EM standard cards or 4-digit PIN codes. Key Specifications 1,000 effective cards/users. Operating Voltage: 12VDC ± 10%. Access Modes: Card only, Card + PIN, or PIN only. Dimensions: 119mm x 76mm x 21mm. www.goldbridgesz.com Programming Instructions To perform any programming, you must first enter the Program Mode Enter Program Mode: + [Master Code] + (Default Master Code is typically Exit Program Mode: Command (while in Program Mode) Add a Card + [Read Card] or [Input Card Number] + Delete a Card + [Input Card Number/ID] + Change Master Code + [New Code] + + [New Code] + Set Door Open Time + [TT (00-99 seconds)] + Delete All Users (Use with caution!) Access Mode Settings You can configure how users gain entry: МікроАмпер Card OR Password (Default): Card AND Password: Password Only: Maintenance & Troubleshooting Factory Reset: If you are struggling with a specific setup,
Remove the back cover from the keypad using the supplied security screwdriver.
For more detailed technical specifications and troubleshooting, refer to official OboHands user manual downloads . For remote access, pair it with a separate
Are you using an or a simple 12V adapter?
The back of the V2000-C features a wiring block. Correct wiring prevents short circuits and equipment damage. Wire Color / Label Description Power Positive Connects to 12V DC positive power supply GND Power Negative Connects to power supply ground PUSH Low-level Trigger Connects to exit button or power supply push terminal OPEN Door Button Connects to one side of the exit button NC Normally Closed Connects to the positive side of a Magnetic Lock NO Normally Open Connects to the positive side of an Electric Strike COM Common Terminal
| Step | Action | | :--- | :--- | | 1 | Press * + Master Code + # | | 2 | Press 1 (Add User) → # | | 3 | Swipe card (beep 1x) | | 4 | Enter 4–6 digit PIN → # | | 5 | Swipe same card again to confirm → # |