Micronova Es99 User Manual Site

The machine detects incoming electrical line power is improperly ordered, posing a risk of spinning screw elements backward.

is considered a legacy component. Organizations like Atlas Copco Shop offer to upgrade machines from the older ES99 boards to more modern base control systems. Manual Resources

| Control | Label | Function | | :--- | :--- | :--- | | | PWR | Soft-touch capacitive switch (Blue LED ring indicates active state). | | 2 | INPUT SEL | Toggles between: XLR (Balanced) / RCA (Unbalanced) / USB-C (Digital Stream). | | 3 | GAIN (Trim) | Stepped attenuator from -10dB to +20dB. Unity gain is at "0." | | 4 | LF TONE (Bass) | Shelving filter @ 80Hz. Range: -6dB to +6dB. Green LED active . | | 5 | MF PRESENCE | Bell filter @ 2.2kHz. Range: -5dB to +8dB. Yellow LED active . | | 6 | HF AIR | Shelving filter @ 12kHz. Range: -8dB to +5dB. Blue LED active . | | 7 | AHT DEPTH | The signature control. Rotate to increase harmonic saturation (0% to 100%). | | 8 | OUTPUT VOL | Master volume attenuator (for Pre-amp mode). Push to mute. |

The (often listed as Micro Nova ES99) is an electronic card controller used in industrial rotary screw air compressors. It is prominently integrated into major machinery brands like Ceccato (such as the CSM Maxi range) and Atlas Copco. micronova es99 user manual

Press and hold down the button on the control surface for 3 to 5 full seconds.

: Visual blocks that light up to signal specific internal or electrical system errors. ⚙️ Core Operational Procedures

ES99 Controller Manual * SaveSave Es99 Controller For Later. * 100%100% found this document useful, undefined. * 0%, undefined. The machine detects incoming electrical line power is

The ES99 monitors electrical inputs and sensor thresholds constantly. When a parameter is breached, it flags specific failure codes. 1. Motor Thermal Overload Trip

During manual shutdown or safety trips, the auger stops feeding fuel entirely.

The compressor will automatically stop spinning once the cycle completes. Clearing Stored Alarms Manual Resources | Control | Label | Function

Note: Modifying these settings can affect the safety of your stove. Adjust exhaust and convection fan speeds. Auger Times: Fine-tune the feed rate for specific pellets. Sensor Calibration: Calibrate temperature readings. 5. Troubleshooting the Micronova ES99 (Alarm Codes)

The exhaust smoke extractor's encoder is not sending a speed signal. Inspect the fan blade for physical blockages or replace the encoder sensor.

ES99 Controller Manual * SaveSave Es99 Controller For Later. * 100%100% found this document useful, undefined. * 0%, undefined. ES99 Control by MICRONOVA - Radwell International