Kes Geyser Load Control Timer Manual New -

Will the timer work during loadshedding?

If you desire more granular control and modern smart features, a WiFi-enabled timer might be a better investment. Regardless of your choice, installing a geyser timer is one of the most effective single actions you can take to control your electricity costs. Remember always to have a qualified electrician perform the installation to ensure safety and compliance with local regulations.

If the controller is set to activate after peak hours (e.g., after 8 PM), it may have a randomized delay of up to 30 minutes before switching on to prevent a sudden surge on the power grid.

While holding , press M+ to set the exact current minute. Release the 🕐 button. 2. Setting Daily ON/OFF Schedules kes geyser load control timer manual new

Electrical work should be performed by a qualified electrician to ensure compliance with local regulations. Troubleshooting & Tips

To set additional profiles (up to 16 slots), press again to access 2 ON , 2 OFF , etc.

Before proceeding with installation, it is paramount to understand the importance of safety. Geyser timers are wired directly into your home's electrical circuit and involve working with potentially lethal voltages. Will the timer work during loadshedding

This is the standard energy-saving profile. It is programmed to keep the geyser "ON" for a total of 6 hours on weekdays and 12 hours on weekends. This schedule is designed to provide ample hot water for typical daily routines while maximizing energy savings.

Press the button once. The screen will display 1 ON in the lower-left area, representing your first turn-on time.

The timer comes with four selectable programs that dictate when the geyser is allowed to heat water: Program Status Indicator Operating Schedule (Standard Weekdays) 1 Flash / 1s Remember always to have a qualified electrician perform

The KES timer features a built-in backup battery to keep its memory during power cuts. If the screen is blank, the internal battery may be completely drained. Leave the unit connected to mains power for at least an hour to charge, then press the Reset button.

The geyser is currently powered down, but it will automatically click back on when your next scheduled "ON" program time is reached.