Gunnebo — Speedstile Fl Installation Manual

Check the status LEDs on the optical sensor array. All infrared beams should show a "Clear" status when the lane is unobstructed.

Place an object in the path of the glass wings while closing.

: Ensure potential-free contacts are correctly wired for third-party card reader integration.

Cause: Dirt, dust, or a physical sticker is obscuring an IR tracking beam. gunnebo speedstile fl installation manual

This section synthesizes the core mechanical and electrical procedures found within the .

Connect the power and data cables according to the wiring diagrams in the manual.

: Settings are typically programmable via digital parameters; most units use a platform with in-built RS485 and COMR1 switching interfaces. Check the status LEDs on the optical sensor array

Draw a chalk line on the floor to mark the exact alignment of the units.

Connect the factory-supplied synchronization cables between the Master and Slave controllers.

Connect the signal to the designated exit terminal. : Ensure potential-free contacts are correctly wired for

Maintain an ambient operational climate between 0∘C0 raised to the composed with power C +45∘Cpositive 45 raised to the composed with power C

To preserve your warranty and keep the speed gates running flawlessly across millions of cycles, adhere to this preventative maintenance schedule: