Slide the "RUN" switch back to the "RUN" position. The colon between the hours and minutes should begin to blink. 2. Program ON/OFF Cycles
16A resistive load, 4A inductive load (approx. 250V AC) Time Base: Quartz-controlled sync with mains frequency
Last updated: 2025. Diehl is a trademark of Diehl Stiftung & Co. KG. This article is an independent user guide and not a replacement for a certified electrician’s advice. diehl multi timer 181 5 manual
: Internal battery reserve (retains saved schedules during blackouts).
: Push the segments outward (away from the center) for the hours you want the appliance to run. Slide the "RUN" switch back to the "RUN" position
This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.
If a high-draw motor was connected without a separate contactor relay, the internal silver contacts may have burned out. The Clock Ticks But Switch Fails Program ON/OFF Cycles 16A resistive load, 4A inductive
: Loss of mains power or a failed internal motor drive.
Technical specifications
The terminal block on a standard is labeled L, N, and two switching contacts (typically 1, 2, 3, 4). A common configuration (5 terminals) is: