Ddcs V3 1 Firmware Update 〈Top 50 LATEST〉

Use a small capacity USB drive (strictly 8GB or 16GB). The DDCS V3.1 often struggles to read USB 3.0 or high-capacity drives during the bootloader phase.

Turn the power off, remove the USB flash drive, and turn the power back on.

More responsive E-stop handling and limit switch logic. 2. Pre-Update Checklist ddcs v3 1 firmware update

If the machine moves in reverse, your motor direction parameters were likely reset. Simply toggle the direction bit in the settings.

: Adds software support for subroutine nesting with unlimited levels (specifically in version 2020-03-06-112). Unit Compatibility : Adds a toggle between Metric (mm) Imperial (inches) Use a small capacity USB drive (strictly 8GB or 16GB)

After the update, it is highly recommended to check your configuration settings, as some parameters might reset to default. Verify your "pulls per unit" settings.

Ensure the power to your DDCS V3.1 controller is completely . More responsive E-stop handling and limit switch logic

: If your machine axes move incorrectly after the update, you must manually re-enter your motor steps, limits, and probe settings if they weren't backed up. backup and restore

Navigate to the Page Zero (Sys Info) menu using the controller buttons. Verify that the software version and compilation date match the update files you downloaded.

Take photos of your current "Parameters" pages. Updates sometimes reset your motor steps and travel limits.

Insert the SD card into the slot (usually on the right-hand side).